easily

Have a H50 that I need to pull the flywheel on to check out the kill switch wire, bike was running fine last summer then died and wouldn't start. Cast Iron Flywheel has no tapped holes for pulling. Any ideas?

looking to get this engine to replace the 5 Hp flat head. Pros/ Cons. looks like there are a ton of parts and reference on this site. I'm too lazy to look. can throttle be easily adapted? fab own brackets, or is there a cheap aftermarket? this will be going on a sensation mb-6 with...

Up for sale is this extremely rare and valuable Rogue Mark IV. This is not a Cheyenne Tomahawk, but an actual Rogue! Features the original Earles front end and shocks! Original handle bars sport money-making PATINA! It is not rust, but actual PATINA! The original red paint was...

how fast were the widowmakers with the sachs two stroke and torque conv.? i'm assuming they would easily outrun a rupp black widow?

Ok, I feel like a complete dumb ass right now becaue I just put a new piston/rings in a 3hp I/C bore Briggs FH. I made sure to lube the piston and cylinder up good with 30 weight oil before intalling the piston. Now that the piston is in, when I spin the motor over by hand with the flywheel on...

I have recently managed to get my 5hp running, but the trouble is, it only starts if you prime the gas tank (one person blows through a hose into the fuel tank, the other works at the pull start). I thought it was the diaphgram, so I changed that for a new one, but it has made no difference...