I have an older B&S 6hp with a 1" threaded shaft.
Are drive clutches made specifically for threaded shafts, or do I need to have it ground smooth?
Can I just cut a keyway and drill and tap the end of the shaft?
Oh, and could I turn the shaft down to 3/4" or should I leave it at 1"? I'm thinking...
I just bought the engine not too long ago and took it out of the box and put it on a mini bike and i tried to start it but it wouldnt spark. It sparked for a little bit but quit . i replaced the spark plug and its still not getting fire. Has anyone had this problem? Can anyone please give me...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.