mig

I'm looking at getting a new wire welder and have come down to two possible choices...The Lincoln 140 or the Hobart 140... anything above them require 220 volt and I don't want to be limited to one corner of the garage to plug into.. The 140's are 110v where I can take it almost anywhere if...

I need to do several jobs that require a good bit of aluminum welding and since my older Lincoln MIG won't take a spool gun I was going to trade it in for a newer model. I happened to see an ad for the Eastwood 175 MIG that came with a spoolgun at a price that was lower than what the difference...

i needed to take a break from writing code for the electronic system so here's what i did today: a while back rayvel shipped me out two cast aluminum bonanza kidney bean wheels that had chucks removed. i filled in the missing chunks with aluminum wire that the mighty mig welder deposited. the...

i finally dragged out the spool gun i bought a few months ago to see how well i can mig aluminum. not so good: blobs, little penetration, not sure where to start. i can mig ferrous metal 'ok', not great, but this welding looks worse than a cub scout den project. obviously i need...

Hey gang, anyone have one of these northern tool do-it-all welders, or know about them? Im interested because of the multifunction, and shop space. FREE SHIPPING — Klutch MIG/Stick 220SI 230V Multiprocess MIG/Flux Core/DC Stick Welder with Included 10ft. Spoolgun — 140 Amp DC |...

Been working for a week now and just about done with it . It will hold my Hobert 140 mig and my new Eastwood AC- DC tig welder . Also will hold two bottles, 100 percent argon and the 72-25 for the mig . Still have two finish the cable holders , the flat steel loops on the legs will have 1/4...

Im looking to buy a MIG welder but dont have too much money to spend.. Can anyone direct me to the cheapest MIG welder with still decent quality, not a garbage welder, thanks!

I was wondering if any body knew where to get a decent priced tig welder. I currently have a lincoln mig welder and wanted to get a tig.

Do most of you use a tig or mig welder for building custom frame?