n.o.s.

Here's a set of Jackshaft Plates. Bearing hole is 1 3/8", Plates are 1/8" thick. the mounting holes are slotted 5/16". These are almost the same as the Comet brand. They are New Old Stock. They'll work on Trail Horse, Roper, and other frames already set up with the tabs, or you can weld your own...

Sprocket ONLY Fits Azusa HexStar rims with five sprocket mounting stands or flanged drum brake hub shown below: 20 Available $5.00 each Delivered Send me a PM (Private Message) if interested.

I found a NOS never fired Raptor for 175 bucks. Is that a good buy? It would be used in a vintage racing kart but not raced....just for fun. Depending on gearing, how fast could the cart go with no engine mods? Thanks!

Here is a set of New Old Stock Chrome Rupp minibike shocks. Part # 11582 . Apparently never been out of the packaging. Bottom chrome is chipped some from plastic being open. Total length is 11 3/4", Mounting bolt center to center is 11". I don't know which models these fit. Proceeds go to...

New Old Stock rear shocks. Some scratches from being moved around. 11-3/4" center to center mounting. Uses 3/8" OD bolts. Springs are 1-1/2" OD. $35.00 Delivered. Never seen this style before. @@@@End of Sale@@@ Sold...Sold.......Sold.

Brand new, gasket is a little stiff with age. $25 shipped. I have 3 of these. Postal money orders only, sorry no paypal.

This tank was brand new when I got it. I painted it and used it for about ten minutes on a bike. It has the mounting brackets with it. It's painted with automotive urethane with hardener so it is gas will not effect it. It does have one small little ding in it that was there when I took it out...

New Old Stock Horstman aluminum connecting rod. Part Number : 4HRB-5 Probably for a 5hp Briggs engine, but I don't know. $50.00 delivered or best offer over a dollar. (Or trade for 57 Corvette) PM me....if you dare. . .

This style spocket was used on the 5 inch Azusa "HexStar" rims. $15.00 Delivered. .