this was sent to me from the machinist workshop mag. "average torque load to loosen a rusted bolt".[1] no oil=516lbs. [2] wd-40=238lbs. [3]pb blaster=214lbs. [4] liquid wrench=127lbs. [5] kano kroil=106lbs [6]atf & acetone 50/50 mix=53lbs. for what it's worth:drinkup:
Does anyone use synthetic oil mix with an older 2 cycle motor, i.e. Sacks with a 24:1 mix ratio. I want to get rid of the 2cycle oil smoke when running, maybe Torco oil?
Hi All,
I need to change the oil in my Tecumseh Power Sport 5.0 hp engine.It's # OH195EA-71237G.What are some recommendations on what oil to use.My oil now is dino,not sure what the previous owner used.What about synthetic or semi-synthetic? What weights etc. Thanks.
Tim
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.