problem!

Hey guys, I've recently been having a problem with my 212cc Predator. My bike starts up just fine and has no issues but when I switch it into run, the engine dies after about 5 seconds. The gas is on and I'm not really sure what would cause this to happen. The engine also is relatively new and...

I am building a taco Frijole minibike, and we're doing it in the monster theme like on the taco website. So we decided to paint the engine cover and the starter cover, when we went to put the engine back together, and we pulled the starter, it wouldn't engage and rotate the engine, any...

Okay, so i got my new doodlebug today and after i put it together, it wont even start. when i finally got it to start the engine killed after i let go of the throttle. Any suggestions please:shrug:

so i just bought a gx160 14cc head and 1.3 billet ratio rocker arms from AGK and it seems like the stock push rods aren't long enough to even come in contact with the rocker arms (rocker arms screwed all the way down) do these 1.3 billet ratio rocker arms require longer pushrods? or...

Hello everyone I hav an 5 hp b&s flathead and I'm in the process of taking it apart and I ran into a problem which I think that the crank case side cover bearing bit onto the crank shaft. So basically I've done all the steps necessary to take the side cover off of the block, so how should I free...