right?

is it just me or do the handlebars look excessively tall on this bike? they are definitly taller than the bike I have here, but the seat on his is longer so its probably a different model or year. I looked through the photos and brochure pics, they actually look kinda all over the...

And if not, WHY NOT? (click on the pic to view) Everything is rubber coated so nothing rubs on a hard surface... I actually had to take a bit of the rubber off to get things rotating. We'll see how it looks in a few hours. :scooter:

Thanks in advance for you help guys.

Tonight, I was out cutting the grass, trying to get it done before the 100 degree heat comes back tomorrow. The grass was long, and it was getting hard to see. I hit something, and it pretty much just stopped 17hp twin Briggs in its tracks. Turns out it was my ball glove, the one my dad gave...

A couple days ago I took my Keystone mini bike for a test ride. It has 12 diameter wheels, 6.5hp clone, with a 11 tooth clutch and 54 tooth rear sprocket. This combo knocked me on my ass and doesn't allow me to exceed 20mph because then the front starts to lift. I was thinking that I would...

Most parts currently acquired and now ready for paint!

Okay, so i'm trying to upload photos from my pictures library on my computer, and when I click on a picture and the file name pops up in the place where it says Browse right next to the bar. And I click Upload/Submit, then it takes about 3 minutes until then it pops me right back to the same...

I just inherited a completely stock dirt bug and aside from the carb leaking it seeming has no bottom end power??? Im 200lbs fine... but it will barely even move from a stop and i have to keep the throtle pegged the whole time...Is that normal for the 97cc engine? Its really unusable

I have a clone that is modified on a baja mini with.265" Lift cam, 26lb springs,1.2 rockers,molly push rods, stainless valves, stock head and mikuni carb 22mm setup,exhaust Header(Open pipe with muffler) and no govenor......i have been having trouble with it not idling right...I has a 17.5...

i have a briggs 5hp with a techumseh carb off an HS40 motor, it has a 6" pipe with a standard briggs sausage muffler on the end, i dont know if im running lean, or rich, it seems if i turn the screw 1 turn in or out, it dosent do anything, when i hit the throttle, it had a delay till it...

Just picked up a new master of motion/Hillard clutch from Tractor supply for my baja heat 6.5 Took it out of the package the the pieces slid right apart, is this right? Looks like there is the outer case then the bronze bushing insert and then the clutches themself I have never had a...

Went to look at a '58 cushman highlander which did not pan out (hacked pretty bad) and found these in the guys garage as well, bought them both. I don't normally mess with the small wheeled pull starts but I am am pretty sure the one is a bird and the other is a cat. Is the cat a...

Just picked this up, as it looked to be in decent shape, and I hope to get it started. It looks like a Rupp, but is it?