spec

Ok I did as much searching as possible and all I found was a torque spec. How much do I tighten down the Jam nut on the driven? What should line up correctly in a static position ect? The torque spec I got was 14ft lb. but that was also on a GTC set up... I tightened it up enough to bring the...

Does anyone know what the torque spec is for a 70 H60?

I ordered several of these seats and had them custom made from OldMiniBikes Forum Seat Made By (N8BALL or Kenny) Sold off my Cats I have one extra unused seat left professionally made to correct specs Black Top Gold Sparkle sides Cant Load any picks on OldMiniBikes (Its my computer) will gladly email pics...

Late 60's CCS Charger Spec Sheet

Hey Fellas, I need a ring end gap spec for a Tecumseh H35-45366J. I looked around online, but I don't see it.

I`m looking for the torque spec for a Grey Hound 6.5 engine flywheel.

Whats the torque spec in ft-lbs for HS50 head bolts?

Does anyone have a readable Bonanza spec sheet. I see the ones in the Bonanza pics on OldMiniBikes and at Minidoodle....but you can't read them. I was hoping not to have to buy one off Fleabay and get one here. Thanks for any info.

If anyone has a 68 slant guard z50 I could use a little help. I am trying to confirm the measurement for distance between the holes for the muffler guard. Any help would be great.

was wondering if anyone knew the torgue on the 11horse greyhound?

My Mil Spec mini bike. 6.5hp 200cc engine with upgrades bringing it up to around 9hp. Hillard clutch, tach/hourmeter and speedo/odometer. Top speed 40-45mph. This was designed as a purely utilitarian vehicle, a fast attack vehicle on 2 wheels. Travel distance is in the 50-70 mile range on one...

hey everyone im putting a new rod in my uncles snowthrower it has a 5hp tecumseh the model number starts out hssk50 and i was just hoping someone could help me find out the tourqe specs for the conecting rod and the head bolts thanks for the help let me know

just wondering if any one knows the torque specs for a honda g200 for the crankcase bolts. or is it ok if i just make them tight and make sure the torques are even with a torque wrench?

I need a spec # from a hs 40 with BB crank Rupp type HS40 XXXXX Could someone look at one for me please. And post. Thanks in advance, Randy

I'm rebuilding my HS40 and its been a while since I took it apart. I think I set the timing right by lining up the line on the cam with the mark on the crank but at TDC the intake valve is slightly open. It doesn't look right to me but is this correct? Also does anyone have a list...