triple

I'm looking for a 71 Rupp 12" tire swingarm and triple tree. They must be in original Rupp red paint. I have other triple trees and swingarms, but need this color to finish putting a bike together. Thanks!

I made up a few Taco 44 flat swing arms and taco fork triple trees .....the flat swing arms a weld could be added to make them perfect but work just fine with out .....$40 shipped as I only have a few .......The triple trees are $35 shipped as I have many .....im full on OldMiniBikes file photos so e...

Custom Forks - $50 Shipped (Anywhere in the lower 48) These were custom made by someone and have not yet been drilled out. The tubes are about 44 inches long and 1 1/2 inches thick (OD). Tube sidewalls measure about .096 thick. They are 5 inches apart, center to center. There is 3 1/2"...

I am recovering from hopefully the last surgery I will need in my fight against cancer... I have been fighting very hard and though times are rough, there is light at the end of the tunnel... In my "down" time, I have been working/programming and designing some parts and misc things, both mini...

Recently I bought a old Rupp roadster? Anyway it is the rupp with the 12" wheels. I have dealt with dirtbikes and gokarts before but this is my first experience with a Rupp. I assume my handlebar clamp setup is stock, as I have seen other pics on here of Rupp/ Speedway bikes. For all...

I just bought a '76 KV75 ... I want it to be a miniature (somewhat) of this ... I'll most likely be asking questions on where to get parts and stuff like that ... anyway ... glad to be here.

I'm not sure if this matters, or if I would notice the difference, but I was just drawing up the triple plate design for my fat tire bike and got to wondering... If the triple plates have offset built in (the fork tubes forward of the pivot point) should the handle bars be mounted in line...

Here is the deal, I want to add front suspension to my Azuza Mini Bike. I have bought a set of Yamaha PW50 Forks from a seller on Ebay. The problem is that the seller can't read a tape measure. They are too narrow by about 3/4". I want to even use a PW50 steering head to upgrade to...

My attempt at Triple Trees/Forks Ive recently had a few things laser cut for misc projects... while there, i asked my friend, who owns the shop, if he would mind telling me the program he uses, so that i could design some of my own parts and bring it to him on a thumb drive. He said not only...

Hey Fellas, I had these triple tree plates laser cut a while back for some forks I was planning to make but never got around to. They are a perfect match for Taco forks but you can use them for any customs forks as well. Made from 5/32" steel just like the originals. $25/pair plus $6 for...

Russ Collins triple engine Honda 750 Top Fuel dragster

chrome

minimoto project drag bike PART 1 - YouTube

fork lowers

triples trees 70s roadster

New, outlaw fab shop billet triple trees, 5/8" bolt hole, 7/8" fork tubes. i have 2 pairs $90.00/pair shipped lower 48

this is a very Rare vintage racing Kart only about 100 were ever made . most would restore it with maybe 2 vintage 2 cycle engines but not me . while I respect that this kart shouldnt be hacked up with wild mods I am not above bolting 3 modern animal engines to it and some good modern brakes ...

billet aluminum triple trees, 5/8" bolt hole, 7/8" fork tube holes, 6.875" center to center. can easily be polished. $115/pair shipped 2 pr available mark

Three 2 HP Briggs Engines