I am building up a new 6.5 clone motor. When it's done, I will be in the vicinity of 15HP and the torque will be tremendous i'm sure.
Question - knowing the DB frame was built with a 2.8HP motor in mind, should I/would it be wise to "strengthen" any particular welds or reinforce anything, add anything that will help the frame stand up to the torque?
If so, what welds/points should I be concerned about?
Question - knowing the DB frame was built with a 2.8HP motor in mind, should I/would it be wise to "strengthen" any particular welds or reinforce anything, add anything that will help the frame stand up to the torque?
If so, what welds/points should I be concerned about?