Starting a new thread here rather than hijack one....
I have been dumpster diving and brought home about 12 carbs. Of these I selected these particular carbs to keep ( and stripped the rest for jets and floats and shite ).
http://www.oldminibikes.com/forum/photopost/showphoto.php?photo=13377&ppuser=13726
These are all Chinese and new ( or very new used, soaked in flood but not damaged ). How do I measure them to decide what to use?
I have two clearly marked PZ19, one makrked PC FK I suspect after searchinng Ebay is a 22 mm carb and two more slight larger carbs marked JYUL 29 that I suspect are 24 mm carbs.
I was considering the 19 or 22 mm for my now stock with header but slowly evolving clone. I am making small changes one at a time ( Yes the ARC rod and Flyhweel will be the next changes I spend money on ) and since these were free they followed me home.
I have been screwing around with e tubes and jets trying to get my stock 16mm clone carb to run well and I don't think there too much point in spending money or too much time on it ( piece of Shite I can't seem to richen where I need it ).
Please share your thoughts and sugestions on what to chose and how to tune these.
I have been dumpster diving and brought home about 12 carbs. Of these I selected these particular carbs to keep ( and stripped the rest for jets and floats and shite ).
http://www.oldminibikes.com/forum/photopost/showphoto.php?photo=13377&ppuser=13726
These are all Chinese and new ( or very new used, soaked in flood but not damaged ). How do I measure them to decide what to use?
I have two clearly marked PZ19, one makrked PC FK I suspect after searchinng Ebay is a 22 mm carb and two more slight larger carbs marked JYUL 29 that I suspect are 24 mm carbs.
I was considering the 19 or 22 mm for my now stock with header but slowly evolving clone. I am making small changes one at a time ( Yes the ARC rod and Flyhweel will be the next changes I spend money on ) and since these were free they followed me home.
I have been screwing around with e tubes and jets trying to get my stock 16mm clone carb to run well and I don't think there too much point in spending money or too much time on it ( piece of Shite I can't seem to richen where I need it ).
Please share your thoughts and sugestions on what to chose and how to tune these.