Im looking for a 7/8" 2" radius for my buddys hossfield tubing bender to complete a job for me. Let me know if some has one i can buy or borrow. thanks guys
Why not just make one ? I have a Hossfeld and after seeing the cost of factory dies, I made several sets out of aluminum. For 5/8', 3/4", 7/8", and 1" tube all in 2-3-4-5 inch radius.
Even a wood die would work for a one-off project :shrug: If the dude has a Lathe its a simple task :wink:
Here`s a hand full I just pulled out of the box:
This is one complete set:
The round follower (with the X) works a little smother than a flat one does. The block is the holder that is stationary on the bender.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.