Finally got back at it , building a Bearkat Twister frame . Review bought what I was told was a Bearkat Twister roller . Hmm not really, it was a bad attempt at copying a original one . What I salvage was a set of wheels >> front not going use << swing arm forks TC and jackshaft assembly , and a very done 6hp Briggs . I had to buy a bender JD-Squared and tube notcher frame jig kit from chopsource . Always wanted notcher and a bender . Haven’t welded in en mount tubes , till I get engine plate ether bought or make one .
Attachments
-
2.5 MB Views: 163
-
2.5 MB Views: 167
-
2.7 MB Views: 138
-
1.5 MB Views: 131
-
2.2 MB Views: 114