Need parts. What is the bike and engine

[Jayminibike1]

It primarily needs a new intake manifold. Also a carb rebuild kit, manifold gasket set and shut off wire/button.

 

[mchadsey1]

It primarily needs a new intake manifold. Also a carb rebuild kit, manifold gasket set and shut off wire/button. View attachment 312052 View attachment 312053 View attachment 312054 View attachment 312055 View attachment 312056

Engine is a sears branded tecumseh h35. Unsure of year

 

[RobertC]

Hello @Jayminibike1 ...welcome to the Oldminibikes.com forum !

Your mini bike is a Sensation Mike Bike model mb-6a.

https://www.oldminibikes.com/forum/...ion-mike-bike-mb-6a-color-sheet-1-jpg.152795/

Nice little bike. The forks need cold bending back in to shape. While the motor is off, remove the front wheel. Secure the bike frame upside down by the front fork. Use the bike to pull up and bend your fork back in to shape.

Keep us posted on your progress !

 

[Jayminibike1]

That's fantastic! I appreciate the brochure! It was originally white and blue . Somewhere there's a picture...

Where would I find the intake manifold piece that is broken in the picture? Also the intake gaskets?

I tried looking up the engine at jacks small engine but it didn't work.

 

[sparkwizard]

Look on Ebay for that intake and carb. That intake with the tiny hole and sharp bends can be replaced by a one piece manifold from a Tecumseh H35. https://www.ebay.com/itm/4009002922...MI77_krpXohAMVxVBHAR3yjwjEEAQYAyABEgIj6vD_BwE

 

[Jayminibike1]

I've done well so far, I have gotten the correct intake pipe and a new kill switch/button. The carburetor housing flange had been damaged and is not usable. I have another one that looks to be identical that came from a 5hp B&S engine. These are diaphragm carburetors. The original minibike 3.5hp Tecumseh carb has 187 6H18 stamped on the mounting flange. The 5hp B&S has 187 6F13 stamped on the mounting flange. Is there a difference in jet size for a 5hp vs. 3.5hp or other internal difference?