Hello Everyone, I made a post here last week about my briggs and stratton 3hp.I replaced the breaker points ignition to the electronic system. It had a flywheel key that was sheared in half, and thus I was unable to start it. I have replaced the key, and torqued the engine to the proper specs. I sprayed starter fluid into the carb, and got more firing than with the sheared key, but still it will not start. I am just wondering where to go from this point.
Attachments
-
2 MB Views: 8
-
2 MB Views: 8
-
116.8 KB Views: 8
Last edited: