WANTED: Steering Bushings (dims included) ??

SCARE

New Member
#1
I am after 2 x replacement Steering Bushings for my Deckson Daredevil :eek:

See below for photos and dimensions (excuse me, we are metric over here, I think I got the conversions right) 8)

Any help would be greatly appreciated!







 

george3

Active Member
#2
I am after 2 x replacement Steering Bushings for my Deckson Daredevil :eek:

See below for photos and dimensions (excuse me, we are metric over here, I think I got the conversions right) 8)

Any help would be greatly appreciated!







why dont you just buy the bronze bushings? Much better
 
#5
those are kind of an odd ball....5/8 i.d. bushings are typically 3/4" o.d. .......you may need to have those made by a local machinist...
 

Scottessey

Active Member
#6
those are kind of an odd ball....5/8 i.d. bushings are typically 3/4" o.d. .......you may need to have those made by a local machinist...
I agree. I took a look on McMaster Carr and with that OD and length, the only ones available were for 3/4" shaft. That was the same for both bronze and plastic. Is it a bolt that runs through it or part of the forks?
 

george3

Active Member
#7
They use them in low quality wheels. the size you need I am not sure. I have some in the garage somewhere but they are prob. 1" od and 3/4 id. Look for plastic wheel bushings.
 

SCARE

New Member
#11
so, a mate has come to the rescue, and has a cousin who owes him a favour or two, so i am getting some custom bronze ones done for me! :thumbsup:
 
Top