Wards T555 trike

[al "off road"]

Up for your consideration,
My rebuilt Wards T555 trike (from the ground up).
Runs and drives great
Sandblasted and repaired where required.
Added/replaced 4th bearing mount, replaced rear sprocket guard, and
fabricated a replacement foot rest (OEM was removed)
Also fabricated a new brake mounts added new drums and replaced front fender. - again missing for wahtever reason-.
Front forks are straight.
Differential was taken apart cleaned and bushings replaced.
New bearings thoughout.
Tecumseh 6 hp OHV engine with comet CVT clutch.
This is the T555 with the "hinge" in the middle but there are no springs (bolted solid).
Located in Northern Colorado/Southern Wyoming area.
video "demo" located here..
Wards t555 trike - YouTube

No delivery available.
Shipping or pickup would have to be the responsibility of the buyer
Asking $400
contact for more information or progress pictures.

 

[70sVintageTrikes]

Sorry to correct you..

That appears to be a Bmb Dragst'r frame. They were made in Holten KS.

If you look at the "suspension" Joint in front of seat, T555's was a 3 bolt triangle.

Pictures below are of mine and picture of my repop decals.

 

[al "off road"]

Thanks for the information. The guy I bought it from was happy just to get it gone.
It looks very much like the wards machine, did one or the other copy it?
Might you know what type of springs were used?
Spring rate, wire diameter etc?:thumbsup:

 

[70sVintageTrikes]

Well mine is about 30 miles from me. They are about 2 inches long and 1 inch round if I remember correctly. But very similar to a valve spring on a engine head.

 

[al "off road"]

Bump

 

[al "off road"]

Bump. -Reduced to $350- bump

 

[al "off road"]

Sold!!!