Which header would be best?

M

michigandon

New Member
#1
#1
Hi Fellas! I found this place by Googling "Galaxie Chopper". :thumbsup: Anyhoo, I attempting to install one of the 99cc Horrible Freight engines into a Power Dyne frame. The biggest problem I'm encountering thus far is that the stock muffler is not going to work for reasons which should be fairly obvious by the pics. :eek: I'm trying to determine if there is a header/muffler for the Honda/Clone engines that would work for my application. Most seem to point the pipe in the wrong direction. :shrug:

Ideally, I would like to find something that would point the exhaust straight down on the ground.

Any and all help would be appreciated.
Don
 
M

michigandon

New Member
#5
#5
cheezy1 said:
Umm...I have a 6.5 on a Powerdyne Rail with a TAV and header and there was nothing done to harm the frame.
Click to expand...
Don't suppose I could trouble you for a pic?

Because I measured 'em both and the smaller one appeared to be a much "easier" fitment for this particular application. Believe me, I woulda bought the bigger one if the height wasn't a concern.

TIA,
Don
 
cheezy1

cheezy1

#6
#6
1/2 to 3/4 spacer plate under the motor...header pipe from BMI karting with a little heat to slightly bend in one spot. I will try and dig the bike out and get a pic...but it is burried in the pile so please be patient.:laugh:
 
R

rmm727

Active Member
#10
#10
michigandon said:
And hack the Hell outta the frame to make that tall SOB fit.

No thank you!!!
Click to expand...
A 196cc isn't tall by any means. You act like we are asking you to put a flathead in it. Use a remote fuel tank and height comes down considerably. If you are hell bent on using that 2.5hp, put a jackshaft on it like the promod one.
 
You must log in or register to reply here.
Top