$20

Bare, cleaned, unneeded. My parts washer solvent discolored some, but it blasts back to shiny. $20 each plus a couple bucks for the mailman, unless you're accidentally in Flint MI. One is a new clone, with mild porting, others genuine. I need billet rods and cams for an HS50 and HM100

$20 shipped to the lower 48 ...

20 series Comet driver in good condition. needs to be cleaned up. $27 shipped

Tecumseh H70 (off snowblower) metal gas tank with cap asking $20 plus shipping PayPal preferred.

For sale :you pay shipping: -DB 30 front wheel good condition no bearings - $20 - Stock animal cam ( can be used in Briggs Intek 5.5hp - 6.5hp ) -$20 Will post pics later or can do via text too. PM me if interested.

Pretty rough but dosent apper to have any holes. $20 plus the ride no gas cap

Tecumseh h50 lighting coil block has block,head,piston,rod,lifters,and cam . i am never going to do anything with it so $20 plus shipping :thumbsup:

Cat kickstand. I bought this for a project, but it doesn't work for what I needed :doah: $40 plus shipping Rupp Reproduction light $10 shipped Sebac Shocks. Eyes aren't stuck, need to be restored/rechromed $20 each plus shipping Betor shock (I actually have two of them, but only 1...

a little rough great for parts $20 shipped :thumbsup:

very nice slightly used 7/8 th's grip set 32/36 cable $20 shipped

Shipping not included in prices in case you want more than one item, all came off a Butcher bird that was butchered :laugh: Wheel #1 (bearing and spacer included, OG hardware) $20 wheel #2 (bearing and spacer included, OG hardware) $20 Sprocket $18...

I got these with an NOS motor that I bought. The newspaper that wrapped the exhaust in the box was from 1978. Looking at $12.00 shipped ...and if that is out of line on price, please let me know. I have seen them sell for $20 on eBay without the other 2 stickers. And of course, if another...

Frame has a 3" stretch and new engine plate, straight forks $60 wheels and tires in good shape, rear wheel has a new 72 tooth #35 sprocket $60 fenders $15 factory peanut tank $25 seat $10 (small rip) rear shocks $20 all prices plus shipping... pics to come, too cold tonight to get some.

Briggs 5 hp flattie Model: 135212 Type: 0130-01 Code: 94120507 Parts: Block -$20 rookie honed and gov removed Head -$15 Has carbon Crankshaft- $20 Cam- $15 Blower housing- $10 Side cover- $10 Tank $15 small pin holes in main jet reservoir, did patch with some steel epoxy...

I have a 4 inch tire and rim i have no use for. Rim has 5/8 bearing and a grease fitting. Tire is a general 410/350/4 . Tire has some cracking but holds air for over 4 months now. $20 plus, $18 shipping usps large flat rate box.

Just pulled it off my new predator. $20 shipped from Grandville mi.

White tank, Has turned somewhat yellow $20 + Shipping

Carb, Clutch and Flywheel. The gas tank has surface rust in it that I need to clean up before I sell it. The motor has no compression so not sure about head condition or valve condition. Exhaust not sure anyone is interested in it or not. Carb $20 Clutch $30 Flywheel $20 See attached...

bigger catch can for sale $20 shipped :thumbsup:

I was digging through Ebay in my usual routine and stumbled across this lot of lights. I am pretty sure the one headlamp is the same that was used on Gilson bikes. I looked at it from every angle available and if it isn't exact, it's really darn close. For $20, it wouldn't be a bad score, but if...