Hello, My name is mason and i recently purchased a coleman bt200x mini bike
I purchased a mikuni (chikuni) 22mm carburator kit with filter for it and i cant seem to get it tuned correctly......
i have not touched the needle nor have i replaced any jets. I am currently using the stock jets in...
Hello, My name is mason and i recently purchased a coleman bt200x mini bike
I purchased a mikuni (chikuni) 22mm carburator kit with filter for it and i cant seem to get it tuned correctly......
i have not touched the needle nor have i replaced any jets. I am currently using the stock jets in...
Hello, My name is mason and i recently purchased a coleman bt200x mini bike
I purchased a mikuni (chikuni) 22mm carburator kit with filter for it and i cant seem to get it tuned correctly......
i have not touched the needle nor have i replaced any jets. I am currently using the stock jets in...
Mikuni vm22 carb with 3 main jets 120,105 and 95 and 3 pilots 15, 17.5 and I can't make out the other. $60 shipped
I'll take some pics when I get home.
Hi erbody need some help here. When I fire up the engine it starts at half throttle, I can give it gas without it dying but can't get the throttle to go down. Maybe I need to put smaller jets in it, the mikuni has the stock jets in at the moment, 100 and 15 pilot I was lead to believe that with...
I have a NOS Tecumseh H50 motorsports engine and I put a Mikuni 22mm oval bore on it.
It gets to 6500 rpm and stutters .. if the throttle is cracked wide open it bogs down.
I have played with the stock jet by drilling it open and adjusting the clip on the pin.
I have tried it with and...
Hello all,
I'm brand spanking new here and I appreciate any help you all can offer me. I purchased what I believe is an genuine mikuni vm22-133 but I have some concerns about the jets.
I bought a new pilot jet that went in with no problems. The main is a different story though. It seems...
I have heard so many times "I just got a genuine Mikuni carb and it was only $29.00 on Amazon!" and in true journalistic fashion, I am trying to debunk this common urban myth!
Genuine Mikuni carbs typically sell for $70-$110 dollars for a VM22 flange type carb. The typical confused consumer...
Is there anyway to adjust the choke rpm speed?
Mine starts with one pull, dead cold with choke on, however rpms are 3500.
Is that what they are supposed to be?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.