retainer

Could use the whole ring/bezel or the piece to repair this one? Thanks Mike

Looking for bonanza swing arm and brake cable retainer that bolts onto the swing arm. Thanks!!

Does anybody know where to buy the retainer that goes on the swing arm of bonanzas? All the ones from OldMiniBikes warehouse are too big in diameter. Thanks

Putting a new main crank bearing (ball) in my rebuild project. I see in the Tec manual a mention of a retaining bolt on the inside of the case cover. When I tore it apart, I noticed there was none installed. I see two holes that look like they could be used for this. Do some people NOT put these...

I am getting ready to install... Black Mama Jr Cam 26lb Springs Should I use Retainer & Keeper Set this or is it only for stainless steel valves? affordablegokarts: Retainer & Keeper Set Or just replace the Retainer for Intake Valve with this so I can use lash cap.. affordablegokarts...

So I've tried to google and such before asking. But i'm still a newb around engines but trying to learn. My boy ordered his 1st torque converter (cheap knock off 90.00 on e-bay) instructions say tav2-30. My question is on the shaft that goes thru the plate and bearings and sleave. ON the back...

Changed valve springs and cleaned the head but my exhaust valve retainer came off while running, Luckily the valve didnt fall in to the cylinder and cause any damage. Anyone know if the valve retainers are different or if my retainer is just bad? THanks

I am at my usual loss. While,removing the wrist pin on my Rupp engine the spring, wire, deal that holds the wrist pin in the piston went flying in the yard somewhere when I removed it. My question, do I need a H35 specific wire retainer specific to the H35 or are they all the same? Anyone...

About what is the max lift that most clones start to experience interference between the spring retainer and the valve guide?

I am trying to get a valve retainer clip. I lost the one side of the clip. This is the split retainer clip style. If anyone can help me please PM me.

When I was chainging my springs out, my exhaust side had a valve retainer cap but now that I'm on my intake side I don't have one on there? Is this normal? I pulled the head off to make sure it didn't fall down but there's nothing. I'm just confused any help is greatly appreciated thanks! This...

Hey guys, I am rebuilding an H70 and upping the compression and have installed a billet rod. I only have 1 bearing retainer but the cover requires 2. Can I get away with 1 or should I run 2? Any idea where I could find another one? Any idea on the part number? I pulled up the...