working on the mystery bonanza and the lower legs slop back and forth fairly much....not enough space to make a shim and wrap around the tube or to insert a nylon liner....
my thought was to put a braze all the way around the lower legs where they fit in the upper half and then use an old...
The torque spec on the nut is 54 foot pounds. I'm curious to know what different methods have been used to prevent the flywheel from turning while using a torque wrench.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.