2015 OldMiniBikes Build Off Open Class Roper

[cdownie3]

Got the exhaust back from the coater

 

[capguncowboy]

looking sharp Chris. Nicely done

 

[cdownie3]

Time to start painting the motor

 

[cdownie3]

looking sharp Chris. Nicely done

Thank you

 

[markus]

:thumbsup: Looking great, the decals definitely look better on the bike than on the sheet next to the bike :laugh:

 

[manchester1]

Wow. That is awesome.:thumbsup:

 

[cdownie3]

:thumbsup: Looking great, the decals definitely look better on the bike than on the sheet next to the bike :laugh:

Wow. That is awesome.:thumbsup:

Thanks

 

[rugblaster]

I have some time and am going through the builds a little at a time and this one looks cool.....should haul ass, that's good. One of the most gruesome injuries of the Buildoff, that is better. should get a award for that. I wish I had been around for the grinder give away.

 

[chipper]

sweet !

 

[cdownie3]

I have some time and am going through the builds a little at a time and this one looks cool.....should haul ass, that's good. One of the most gruesome injuries of the Buildoff, that is better. should get a award for that. I wish I had been around for the grinder give away.

That old Powermatic was a good friend for a long time. I knew the gap between the table and the disc was so worn that it would grab stuff ( my own fault for getting hurt , I was in a hurry ). It will be hard to replace, it was 40 or 50 years old.

sweet !

Thanks

 

[cdownie3]

Painting the motor

 

[cdownie3]

Shock time

 

[cdownie3]

All that crap came out of that shock when I took the bottom off

 

[rugblaster]

looks like my mother-in-law's scrambled eggs.

 

[capguncowboy]

looks like my mother-in-law's scrambled eggs.

:laugh:

I recently bought a couple of pairs of Sebacs and even the almost new pair had that inside them. I packed them full of grease before I reassembled them. Hopefully, that'll prevent the corrosion in the future.

 

[cdownie3]

I see I put one of the springs in upside down:doah:

 

[cdownie3]

First time I have seen smaller springs (and cups)on Sebac shocks 1 5/8 inch

 

[cdownie3]

engine in it's mount

 

[cdownie3]

New jackshaft , bearings and brake band

 

[cdownie3]

Cleaned out the fork tubes with my patented snadpaper on a stick