Been awhile since I've shared an update or pictures.
Adding photos.
Gas tank has been sand blasted, new jackshaft, ape hangers and grips installed, engine in place, battery box wired and installed, start switch relocated and wire harness in place.
I wanted to give the build a lower look so I raised the rear axle up a bit. Need to make it a little longer for adjusting and adjustment brackets need to be relocated.
This week I'll fill in all the old holes in the frame and redo the factory welds. After that its off to the sandblaster.
Still to do: locate the headlamp bucket, decide what to do with the seat and make a top for the battery box.