Clark cyclone jackshaft bracket

[Dave588]

Minibike looks a lot like a rupp. The right jackshaft bracket was cut back. The closest part I could find with swingarm hole on one side and bearing hole was a rupp. It's too small. Clark bracket is much bigger.
Now I am looking for correct bracket or maybe using round type on this site to weld bearing support only?

Anybody have clark jackshaft bracket? Or ideas on fixing this one?

 

[Dave588]

I took the rupp bracket and welded it on inside of frame. On both front and rear face. Then I cut rear wing off. Now I have original bracket on outside supporting swingarm and new bracket on inside supporting bearing. I still have an inch or so for sprocket. Not factory look but it is a clark cyclops, previous owner really was a douchebag. I did take honda gc160 that was lopsided in frame. Removed gas tank and airbox for a k&n type filter.
now I need to order jackshaft and torque converter.