Clutch guard bracket ID?

[JohnnyTillotson]

Does anyone know what this bracket went with?

 

[minibikin']

Hmmm, single mount tab and band brake. Must have been a longer guard that mounted in the rear of the frame also?

 

[george3]

I would think a square front guard. The mount looks a bit forward too much for a round front type guard. Nice brake band set up. I wonder if its in the oem engine bolt holes for the app. I would think so. What mini bike was factory with clutch brake? Take it from there.

 

[thejoker]

I think it's for a band brake.

 

[minibikin']

It would open up the debate of pulling the band the wrong way again....:doah::censure::anon.sml:

 

[capguncowboy]

Assuming it hooks up on the bottom and pulls from the top, it would make the most sense for that band to run counter-clockwise, which is the same direction as the engine is pulling. I thought that was the correct way. Although, the couple that I have set up have been ran clockwise (opposite direction of the engine) because I felt the other way was too touchy grabby

 

[minibikin']

I'm thinking the cable goe sin the bottom at the stud and pulls the rear of the band forward?

 

[gumpit]

Could have had a brake pedal hooked up too. That would be the right configuration.