Db30 with tav and sprocket change help

[durandbagwell86]

Ok, I've made up my mind on what minibikes I'm getting my sons for Christmas. I'm picking up one db30 in the morning after work. I have a stock predator in the box to put on it. I'm going to order the engine adapter for it and get the sprocket adapter for it and run a 53t on it with a tav. I figure it will cut down on wheelies and run good on topend with that setup while the governor is still on it. It will have a bored carb, air filter, and header on it as soon as I put the motor on it. I'm looking at the cheap tav on OldMiniBikes for it and wanting to know exactly what I need to do for it to fit on this db30 with a 6.5 predator. I'm going to build two bikes just alike for my sons that weigh 80lbs, and they'll be running these at the strip after they get the hang of them.

 

[2SlickNick]

I suggest a wheelie bar.
I am running tav with 53t and mine still does wheelies.

 

[durandbagwell86]

I'll build them some wheelie bars too. Is there anything special to do when adding a tav?

 

[2SlickNick]

If you buy the aluminum plate lawn, you will need to cut some of the bottom to make it fit. There are plenty of articles and threads here on it you should be able to find it. Good luck.