fresh clone head, ss valves, milled ect

[125ccCrazy]

new...never run,
ss valves, alum retainers, locks, milled .060, 26lb springs, mild porting

$100 plus ship

 

[JamnJM]

What size SS valves?
Photos of ports?

 

[125ccCrazy]

What size SS valves?
Photos of ports?

stock valve size.... I can get more pics....

head will be good for a mild build which is where I started out but changed directions a little as I got further along..

 

[125ccCrazy]

more pics

more pics... the head is a little dusty from setting but it has never had fuel through it.... I did have a header and intake bolted to it so there is some pieces of gasket material that stuck the the head..

 

[iatemeself]

is this a gx200 head or a predator head?

 

[125ccCrazy]

$100 shipped

is this a gx200 head or a predator head?

clone gx160/200

 

[125ccCrazy]

still avail

I also have a new head gasket and intake manifold

 

[INTHE10s]

Intake for a stock carb or mikuni?

 

[125ccCrazy]

Intake for a stock carb or mikuni?

Jerry I made it for a mikuni taper bore (22mm)...it has the pulse fitting for a pump in it also..

 

[125ccCrazy]

ready to bolt on and go.....

 

[Hreagle]

Will that head work on a 212cc Predator engine?

 

[Sinner70]

i dont think so

 

[125ccCrazy]

Will that head work on a 212cc Predator engine?

Warren, I was told it will work if the guide pin holes are drilled out a little bigger... I can't say for sure, but that's what I been told...

 

[badtec]

Love your work, bro...I do! What I would like to know though is... what "ect" stands for? How is it spelled?

Scott

 

[125ccCrazy]

Love your work, bro...I do! What I would like to know though is... what "ect" stands for? How is it spelled?

Scott

Thanks Scott...

ect= etcetera

I guess it should be etc? lol....

 

[RADustin]

I need to reference the comp chart. But I think I'm correct to say this would put my CR too high for 93 pump gas with a .020" rod and flattop.

Any chance you'll strip the head and seperate?

 

[125ccCrazy]

I need to reference the comp chart. But I think I'm correct to say this would put my CR too high for 93 pump gas with a .020" rod and flattop.

Any chance you'll strip the head and seperate?

it will put you around 12:1 with a flat top piston... that will run on 93 no problem...

I really dont want to seperate it but thanks for the thought...

 

[RADustin]

What cc head is it?

 

[125ccCrazy]

What cc head is it?

before milling 22cc

 

[125ccCrazy]

$80 plus ship before it goes to ebay..

you wont buy a new head, have it milled and buy the new SS valves, springs, etc for this price..