I'm looking to fit a DB30 rear wheel onto my Coleman CT200U. I want to keep the stock axle since that makes thing easier overall. I need 1.25" OD, 15mm ID bearings that are 10mm wide. I haven't found any with that spec with the limited searching I've done.
Have any of you guys had custom bearings made? I'm wondering how much it would cost. I'm thinking that I'd probably just want 4 of them which may be an issue with some places.
I could cut off the mounting tabs for the axle and run new ones that would work with a 1/2" axle, but then I'd have to find an axle that would work for me. Another option is to mill the axle down to 1/2" and re-thread it.
Have any of you guys had custom bearings made? I'm wondering how much it would cost. I'm thinking that I'd probably just want 4 of them which may be an issue with some places.
I could cut off the mounting tabs for the axle and run new ones that would work with a 1/2" axle, but then I'd have to find an axle that would work for me. Another option is to mill the axle down to 1/2" and re-thread it.