Newely built 212 predator smoking when hitting the throttle is this normal

M

mikeholt25

New Member
#1
#1
Replaced rod in added new weisco piston standard bore seemed like the 40 min break in time that quite abit of oil is passing threw the side of piston not bad but enough to smoke when acclerating or hitting throttle hard will this clearup or should i tear down in put stock piston back in took the head off in u can see oil riding up the side of the cylinder wall combustin chamber oily black sparkplugblack
 
Newoldstock

Newoldstock

New Member
#2
#2
Did you hone the bore?

Did you let he engine idle or put it to work right away ( a little light riding )

If you just let it idle it may not have seated the rings.

Do you have too much oil in the crank case( it happens )?
 
M

mikeholt25

New Member
#5
#5
When i first started it throttle was stuck wide open for about 6 sec it did fine tho till about 15 min after i restarted dumb the oil lil shavings about normal re filled with oil did it again no metal sheen refilled it says 14 oz but when i put 14 oz in it it doesnt show on stick it says low so i put more in it with throttle beeing stuck on first start do u think i blew out the rings
 
You must log in or register to reply here.
Top