The engine stand works great. You can flip it upside down to paint underside. You have to make sure it is tightened down good. I would miss a spot ussually when i would hang them.
I tried something a little different just now. I watered down some coarse buffing compound and used a paper towel and attempted to remove overspray from the chrome serial number tag. It worked
I was alittle nervous but went with very light down pressure on it and it slowly disappeared. The raffle bike will have the origanal ID tag on it
I will spray adhesive the decal back on bike tomorrow.
Rick, do you want me to change up the tags this year and add the "20th Anniversary Reunion" or something similar? Also, what do you want for overall dimensions?
Rick, do you want me to change up the tags this year and add the "20th Anniversary Reunion" or something similar? Also, what do you want for overall dimensions?
Jim. The 20th Anniversary Reunion is a great idea. We could maybe put this on one the tank or fender. I will post a picture of tank width and fender width.
Jim. The 20th Anniversary Reunion is a great idea. We could maybe put this on one the tank or fender. I will post a picture of tank width and fender width.
Jim. If we put one on the gas tank it could be as long as 3 1/2"s. And about 1" wide
Fenders could only be about 3" long. Would these measurements work out for the extra lettering this year.
Jim. If we put one on the gas tank it could be as long as 3 1/2"s. And about 1" wide
Fenders could only be about 3" long. Would these measurements work out for the extra lettering this year.
I got a couple things put on the bike today. Wish i had some parts back from the chrome plater i could put front forks together and rear shocks together. I need to run parts up the get zinc plated and get motor into the machine shop. Tore it down and bore is pretty bad. Going to need bored out. I have a .020 piston for it.
Today was like Christmas. I got a phone call yesterday saying that the parts were chromed and the day before i got a message saying the hubs and brake backing plate were burnished. Karen sent me some new snaps for putting seat on. Today everything is here. Thank you Sam Bennett for getting the hubs and backing plate done so fast and Karen Krause for sending the snaps.
I have a question. I never payed any attention to the rear shocks when i took them apart,but why is one tube shorter. Does the short one go for the chain side ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.