Throttle connection help with Briggs please..Thank you!

[tdaddy]

Ok, I don't think I'm doing too bad for a newbie.

Got throttle cable where it needs to be. Idling perfect just need an idea or thoughts on hooking the cable to the arm. Up to this point I have used scrap stuff. Bolts with washer falling off, cause of idle..

Pictures, descriptions of ideas or something to buy any help is greatly appreciated. I've got a picture up and got the finger pointing to the connection needed.

 

[Havasu Dave]

Something like this to clamp the cable.

You can do a search for throttle within the Briggs section here and see a few different posts and ideas.

 

[Harleys Papa]

This is what you need :thumbsup: open that hole up enough to pop it in from the under side :thumbsup: You might find one at a local mower shop :thumbsup:
Wire Swivel w/Screw - AZ2361

 

[jim210]

You can put a cotter pin in the hole and then slide the cable through the cotter pin

 

[tdaddy]

Thanks guys for the ideas. Just put an order in Friday from OldMiniBikes. Damn would have like to have that in the order.

I like the cotter pin idea too.