14 inch speedway. I got jackshaft out with driven. I cant get bearing off jackshaft on driven side, and i cant for the life of me figure out how to get the driven off the jack shaft. im ready to start :hack::grind::weld:
i put inside calipers on my drive and it did read 5/8. before i did this i bought a 3/4 belt and was a little wide especially on drive. I dont know that my driven is original. Any way let me know what you come up with. How are you planning on thinning the belt if you have to? later
looks like its a tc 88 and i need a belt spacer. Does anyone know who carries them? gokartsupply does not nor does mfgsupply. can i just use washers, or does it need to be keyed? thanks
how do i know if my comet drive is a tc 88 or 20 series. Im thinking its a tc 88 cause i just bought a three quarter inch comet belt and it is wider then the brass bushing. Shouldnt the belt be same width as brass bushing. When i put cover on driven and tighten it down, it grabs belt and wont...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.