Just got back home form spending the afternoon at the flywheelers show. I did not get to see it all I did take a pics of a few mini's I saw in the swaps, supposedly there was an all original artic cat there, I didn't see it. I might go back tomorrow though as I spotted a rare bicycle there that...
:doah::doah:that guys back on ebay again with that mini with the strange fenders and a filthy mouth ,he didnt even change the add ,he left it as before , he will never sell with a add like that:thumbsup:
I've been away from the board for awhile...since then I have picked up a ground hawg go-kart for the boys, and a B&S 8hp w/ light coil :) Is there going to be build off during the winter months this year? I am wanting to build my old boonie frame into a "TOP FUEL" boonie w/ a 8 hp Honda...
Now that my hand is becoming usable after my catastrophic wheelie crash about a month ago, I'm starting to repair the damage to my bug. My right side handle-bar is slightly bent downwards at the bend next to the grip.
It's about an inch lower than the other grip. How can I bend it back up with...
so it's been awhile ive been very busy with work and working on my kymco stock it tops out at 30mph iam pushing it to 45-50 when iam done it will cruise at 70 all day :thefinger:
O.k. now that I've identified that there's a compression problem (too low) what are my next steps ? How do I correct a low compression problem ? is this something that a joe hack like myself can do or do I need to send it out ? cost ? and any other opinions that you can share ... I'm all ears...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.