Does anyone know the part number of the Rupp clutch bell used on the Chopper/Cub models with the Tec H25? It has an 11 tooth sprocket for 5/8" shaft and its a smaller overall diameter than the average centrifugal clutch. Mine has most of the teeth broken off so I'm looking for either an original...
My original Wards Gilson mini from , I believe the late 60s, #35 chains ,Has abrake drum that is so worn that I'm not sure of its exact original diameter. I believe it was 4 1/2". But may be 4 5/8". Wondering if the 4 1/2 " drum from OldMiniBikes warehouse would be a good replacement. They do not give...
Is there a hp limit to a chain. why use any chain size over another and jackshaft size.. iv seen small engine bikes with huge chains and large engines with small chains. school me.
Does anybody know what the outside diameter (tip to tip of sprocket) of a 60 tooth sprocket for #35 chain would be? I need it to layout a project I am working on. I have one at home but I am not there right now.
Thanks for any and all help!!
Trying to find the shaft diameter on the 212cc predator engine. Also, the diameter of the 97cc.
Search has turned up shaft length, rotation etc....
Thank you!
I took my intek apart and if I measure the piston at the bottom of the skirt it measures 68.2mm but between the two upper rings it measures 67.8mm. Where is the proper location to measure? Thanks
3hp diam flywheel with removeable fins and adjustable center hub...will need a drop down coil bracket 5980 ARC Coil Bracket Kit GX390 3HP
$100 plus $13 shipping
This should fit Briggs, gx200, ect with a different ARC hub
Hello,
I am new on this forum. I've been reading few of your posts and find them very interesting.
I need to know what was the original carb that came for the Honda Z50, from 1979. It is so rotten that I cant even read the inscription on it. Seems to me like a 14mm but not sure. Are there any...
Does anyone have a scrap 5/8 crank that they would ship to NC for me. I would pay for the shipping and handling. I need to cut the PTO end off of it so any condition crank would work. I do not need a working crank. Thanks.
Would 11/16 diameter drill bit be the right choice for drilling a hole for a 17mm diameter axle, or would 17mm be big enough. I am not sure if the hole in the brake assembly needs to be a little bigger than the axle itself. Thanks.
Hey all,
Anyone know the size of the frames inlet where the forks fit into? I was wondering if my old mountain bike forks would fit, but I am unsure about the size. I know I can just take the fork off and see if it fits, but why do that when I have all of you to answer these questions for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.