h60

A couple quick questions regarding my Tecumseh H60 1. Any tips on getting a stuck flywheel key out. I used penetrating oil, hammer, attempted to pry it up somehow with no luck. Any suggestions. 2. I currently have the side cover removed and find it nearly impossible to turn the engine...

I'm in need of a Tecumseh H50 crankshaft and sidecover for my current project. Does anybody have some used ones in good condition to sell? (see photos below) Engine- Tecumseh H50-65403T SER 1136D (Solid State Coil Engine) Crankshaft- Tecumseh part # 36391 or # 35235 Sidecover- Tecumseh part #...

I have a couple non-bearing side covers for big block Tecs... govenor parts removed...good shape, no cracks or breaks... FREE......pay the shipping

hey guys im going to be building a vintage style go kart the next couple months and for an engine im thinking of using my dinosaur H60. the thing is so old, and i cleaned it best i could, slapped on paint, and called it done. however, now its bubbling off, and looks horrible. enough said, ill...

After further inspection I might need I new carb for an h60 Tecumseh. Can anyone here give me a part number that I can get another one. I am hoping to get a new/slightly used one off of eBay. For under $40. Thanks Nick

I have a mid 60's Tecumseh H60 on a Craftsman tractor and was wondering if this ebay auction is the correct rebuild kit for my carb. The auction says it fits H60's but are all H60 carbs the same, even ones that old. Thanks Nick Tecumseh Carburetor Rebuild Kit 31840, 1408 - eBay (item...

WOW another nightmare custom hand tweaking 3 bends and two rolls and a tab to make it work... About 20 trips to the vice.. :hammer: ... ad a flange thing... Hammer: Good thing I did tube bending for years and tweaked parts thousands of times.. :glare:

Good Lord what a nightmare this stupid thing was. Had to be done so the motor would work in the Grasshopper. An H80 intake upside down with an H40-70 style intake at either end to level the bolt patterns... I ground off the bump from the H80 intake to gain a little clearance and rigged some...

H80 intake upside down with H40-70 intakes manifolds at either end... :confused: What the hell it worked... He insisted on this motor..

H-60 ungoverned with a Tav in a Grasshopper??? He didn't believe me when I said it was gonna be a super wheelie machine.. I think it scares him after two attempts to drive it without a wheelie..