housing

Is it possible to use a V60 blower housing and flywheel on an H60? both are early (around 1969-1970 engines) Thanks!

Looking for a Briggs & Stratton shroud like the one pictured below. The shroud was usually found on models 6B-S, 6B-SF and 6B-SFB motors. The shroud is very distinctive and can be distinguished from others by: Five horizontal bars at the top. B - embossed at 9 o’clock. S Recoil...

With or without fuel line holes is fine, pre 1973 (serial plate instead of stamped shroud). throttle mechanism and serial plate not needed, but would be a nice bonus

Looking for an original black paint vintage early 70s small block air filter housing. Thanks

I need a black original paint blower housing and/or recoil for a 71 hs40 so it needs to be curved top and can be from other years or models from early 70's. Thanks

Tecumseh filter and housing of 5hp big block $20 plus shipping

What is the difference in the housings with the recoil bolts at 3 - 6 - 9 - 12 and the housing that has them half way between at 1:30 - 4:30 - 7:30 - 10:30? Is this changeable or do you have to swap out the cover? Second question - What does it take to convert an HM80 to electric start? More...

Looking for a stock white blower housing with original decals. Thanks

Looking for 2 Tecumseh H big block blower housings without the fuel line holes. Thanks

I WTB (2) white original paint Tecumseh air filter housing the ones that show the holes on top. Not the ones with bell shape caps welded on them. (NO repaints please!!!) Thanks

As the title says....Looking for a good condition Original White Paint Tecumseh Air Cleaner Housing Mounting Plate For an H25,30,35. (No Offset). Will take a whole air cleaner housing assembly if need be. Please PM me.....Thanks in advance :thumbsup:

Need a blower housing for a late 80s new style Tecumseh H35. Example shown below.

Just picked up a nice 5hp Briggs that was used for kart racing, I'm looking for a clutch style blower housing and pull start. Thanks

Looking for this:)

I'm restoring an HS40 for a Rupp mini bike. One of the 4 studs in the blower housing for the recoil starter is stripped beyond repair. The studs look like they are pressed into the blower housing from the inside. (Hopefully they are not welded in!) I'm wondering if I can press out the bad one...

These parts are for a TECUMSEH H-70 Model 130054A Recently had these parts all show chromed and have only been taken out of the wrapper. Selling as a complete set only. The blower Housing has the optional starter motor popout H-70 Blower Housing H-70 Blower housing backing plate H-70...

I'm doing something wrong what am I missing!

Looking for something clean No Dings Dents welds or alterations $$ 1970 Tec HS-40 Lighted Blower Housing

anyone have a complete air filter assembly for a HS50. send a pm :) hope someone can help! I am In Toronto

HS40 points engine from 1978