is there a web site for the engine ? or a real repair manual ? and parts other than Sears and over priced shipping and handling charges ?
Thanks
Smokie
Hi:
Just cracked the crankcase on my GX200 clone. The governor appears not to be working. I found a plastic part in bottom of crank case and the arm is attached to nothing. What is the best thread for repair? I searched but did not recieve what I was looking for. Thanks for your time and help.
I recently had new jackshaft/swingarm plates welded on my Bonanza frame. I used a threaded rod & nuts to keep everything parallel:
http://www.oldminibikes.com/forum/project-logs/51639-project-bare-bones-bonanza.html
Problem:
Unfortunately, Even though the spacing of the plates is parallel...
i have a ruttman grasshopper tank that had rust issues i repaired them and then i sent it to be chromed and it came back with some holes showing and it was bad:/ whats a good way to fix the pitts and holes?!? thanks
Starting to restore a 1968 Taco 22. The frame was damaged. It looks like someone cut and bent up the frame to fit a bigger motor. I have cut the bad welds and straighten the upper frame tubes. I was hoping someone can tell me what the inside measurement is between the upper and lower frame...
I need to find a craftsman who can fix a crack and the bad covering it, the crack is through the weld now. Got the frame that way and it's an El Tigre upper where it joins the neck thats cracked and I need it fixed permanently , also there is a pitted spot where I want removed and a new section...
Started class in October and just passed the half way point. I know this is pretty basic stuff for a lot of you folks, but for the mechanically challenged like myself I am finding this informative and serving a purpose.
Here are the topics covered to date, and tell me in a reply what you...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.