switch

Hello, I am rebuilding a Super Bronc and am looking for a couple of these stoplight switches (photo attached). Notice how the brake cable goes through the switch. I have spent many hours searching google, and this forum, but can't find any like that. Does anyone know where I might find...

I just recently bought a Dunnecycle and I'm re-doing the whole thing. It's all there but I need 2 things: A complete decal set (including the decal on the gass tank) An original kill switch or similar replacement Anyone have any of these for sale?

Looking for the type that has the hi-low beam switch on the front, and then a button on top and near the back side. I've seen similar new ones for around $15-20.

OK, I just bought a Lil Indian w/ a 5hp Briggs & Straton on it. The guy who put it in didn't hook up the kill switch wire from his old engine. He said the wire used to go right to the spark plug, but when he put it there and used it, it shocked him so he pulled it. The current kill...

its just a normal 3.5 hp engine. can u show me some pics on how to hook it up? here is the engine im planning to connect it to,

My go kart has a Modified clone motor on it. The oil sensor is removed so unhooked the oil sensor box on the outside of the motor. Then i just have a straight connection from the thick black wire to the kill switch but it wont turn off. I need help. If this setup is wrong then i have no problem...

in ca, $25

in ca, $25

anyone tried this mod? I copied this response out of another thread- contributed by "altered 7151", but I didn't see any follow-ups to his suggestion..... want to know if anyone has had success with this- quoted below: "For a double kill switch you just need to make the circuit go to ground...

Ok, so I can generally figure out mechanical stuff, but I really struggle with electricity. I have the oil sensor removed from the inside of my clone, but never disconnected the external wire. I have a toggle switcht type kill switch mounted to my handlebars. I still have the original...

Trying to hook up a kill switch to my 5hp engine off a snowblower. I attached the new wire (red in picture) to where the old one came from. (White end of wire in other picture) Im spinning the engine with a drill but get spark reguardless if the new wire is grounded or not. Where am I...

I am at the end of an Azusa mibibike build.I need to mount the motor & install the clutch & chain and it will be ready to roll.On the front of my 5hp Tecumseh engine is a plug with a green & black wire going to it.What color wire do i hook the kill switch to?

How do you install a kill switch ? Right now I'm using a bent wire that pushes down on the spark plug on a B&S 2HP. I'd like to install a switch mounted on the handle bar. Thanks in advance. Tim

got a kill switch from bmi but no clamp came with it to mount to handlebar. i called them and was told i should use a conduit clip to hold it on. well that didnt work. i bought one from a local shop last year that is the same switch except it came with a two piece clamp. it is the toggle type...

I need the dimensions of the switch plate so I can replicate it and make a self starter. Thanks Larry

I need the dimensions of the switch plate so I can replicate it and make a self starter. Thanks Larry :hammer::hack::grind:

i was removing the stock kill switch and i accidently pulled the wire out of the black enclosure...it wasn't crimped very well...... i need to hook up my handlebar kill switch to my new motor and i know one side goes to ground and the other one(black with white stripe) goes to what...

I have a coil off of a 5hp briggs and can I atatch a kill switch to it, any help would be nice.

I have a 5hp briggs with no kill switch. It had at one time the little lever on top of the head to touch the spark plug but that is missing. the coil just has the spark plug wire no wire to atacth a kill switch. Any thing that I could do?