weld

azusa build tank mount

azusa build tank mount

azusa build tank mount

azusa build tank mount

azusa build tank mount

Hey, I have a wheel from a Yamaha bw80 that I may need a brake hub welded onto the wheel's hub. I would offcourse pay shipping both ways and a few extra dollars. I'm just trying to get this planned out ahead of time if I do need someone. Because I'm trying to do this "machinebike" - no...

i got a bunch of flatheads given to me, one (1972 B&S 5hp) looks like a new build stalled, (new .020 piston, alum rod etc) so upon closer inspection, I find the new valve guides are set in JB Weld. I dont know how big the hole is and how much JB is there, but at top of valve guide is JB all the...

Yuuuupppppp:facepalm: . Yesterday I was up till 4am in only my boxers welding and make a rear seat for my mini. All was going good until I tipped my bike over to do some welding underneath the tubing. Apparently the gas tank leaks when the bike is tipped over on its side. After laying on its...

Hi, I got some of these Azusa 1855 Fenders for a Bonanza BC1300: I got a couple of questions on where to weld the tabs as in the original Bonanza fenders: -Does anyone know where I can buy the tabs? -Does anyone have the dimensions of where to weld the tabs? It looks like they go...

Anyone know of someone that can make or has weld on axle tabs plates. Like these, Bad Dog Enterprises - Mini Bikes, Mini Choppers, Parts, Kits & Assemblies Need them for my Speedway Shrike, I can use a 5/8" axle on it.

I have a Tav30 with the steel stamped backplate installed on my Kenbar MB-6 minibike. It has a Tecumseh 6hp OHV engine. #41 type chain, wheel sprocket is probably 72 tooth though I haven't counted it yet. Looks like the same one on the Manco Thunderbird. Almost the same size as my 480/400x8"...

Two spot welds broke on my warrior tank and I was wondering if j b weld would make a strong enough repair for it ? I cou;d get it spot welded but the welders around here really rip you off. Just looking for some input from other people who have used the stuff. Thanks.

I have a small arc welder that my father bought 3 years ago promising to teach me how to weld, but, with him out of the picture I don't know how to weld. Does anybody know any sites that can give a step by step process or anything like that? Any help would be greatly appreciated.

I have a welder to use but not the area to use it so I started to make an exhaust for my Baja 5.5, went to lowes, cost so far ofr these parts are aprox $22.00

crap weld

is there somewhere i can take plans and dimensions and someone can bend and weld pipes to make a frame for a minibike? i really dont want to have to order one online i live in washington