Bremer ... I believe

#42
I wonder if those mounting bosses line up with any factory engine mounting holes, or if a bracket would be needed either way.
A motor plate would need to be bolted to the existing mount area. (wouldn't want to damage the original mounting area).
I wonder if those mounting bosses line up with any factory engine mounting holes, or if a bracket would be needed either way.
 
#43
I can make a mount to mount a Jacobsen 321 on it, but the wheel and jackshaft would need to be reversed, and parts supply is almost nonexistent.
That is why I have so many Jakes in the garage.
 
#45
I sent you PM.
Will and I can bring some small 2 cycles down this summer to see if they will fit in your frame.
It'll only cost you a hot dog and a root beer.
Thank you Dave @sparkwizard when I get to that point, that'll be great !

There's a Highway 55 around the corner, that makes a good hot dog.

Or maybe we can meet halfway , and do a mini bike mock up, in a shopping center parking lot !

Like I mentioned in our pm, I have get focused, and clean it up, then get it rolling-smoothly, then reestablish it's ability to stop, then focus on the motor.
 
Top