Looking for advice on db30

[infidel]

I ordered a tav2 for my 212 predator db30 with basic mods. i understand theres a little modification for the installation but i have searched for hours for a guide/ writeup but have had no luck... is there a thread on the complete installation process of a tav2? preferably with pics.. thanks

 

[jdogg]

Welcome aboard infidel!! I searched back for this particular thread as its a good detailed one that covers your question in detail and then some (lots of good picts too)!! Hope it helps you out!! :thumbsup:

http://www.oldminibikes.com/forum/doodlebug-minibikes/90917-dirt-bug-modded.html

 

[jdogg]

Also note before you begin to read the whole write up as he made some costly mistakes as seen on page 5 where he re-notches a new aluminum Tav backing plate because he took too much off the first one!!

 

[infidel]

Thank you! I plan on taking my time. It's still down until my seat Springs come in..

 

[jdogg]

Thank you! I plan on taking my time. It's still down until my seat Springs come in..

Thought this sprung seat turned out nice....just incase you didnt see it!

http://www.oldminibikes.com/forum/d...spension-question.html?highlight=seat+springs

 

[infidel]

That's the one I'm copying. I'm using 2 inch Springs.. Didn't like the ride height on the 3 inch Springs ..