I'm about to start a new project and need a little advise.I'm going to be using 10in wheels like these,
On the drive side I'm using a 53 tooth split sprocket setup.I was wondering if it seems fee sable to mount one of these,
on the other half of the wheel to use as a brake rotor,after cutting off the teeth and drilling a few holes in it.
Just need to know what you all think,or maybe there is a better way.I haven't found a hub that would work with this wheel to mount a pocket bike or scooter rotor to so this is what I came up with.
Thanks.:thumbsup:
On the drive side I'm using a 53 tooth split sprocket setup.I was wondering if it seems fee sable to mount one of these,
on the other half of the wheel to use as a brake rotor,after cutting off the teeth and drilling a few holes in it.
Just need to know what you all think,or maybe there is a better way.I haven't found a hub that would work with this wheel to mount a pocket bike or scooter rotor to so this is what I came up with.
Thanks.:thumbsup:
Last edited: