Taco 22 frame question

[Scottessey]

Hey Fellas, I have a Taco 22 that has a couple holes in it and I'm wondering if you Taco owners have seen this before or if I should figure these were added later and make them disappear before paint. They are on the top (kind of under the seat area) and also on the two rear tubes (a little below the seat). Thanks. :thumbsup:

Can't wait 'til Funday! unk:

 

[1stlegendtx]

Fill em in. What year is that?

 

[Square_Chopper]

No holes in Jared's Taco frame..... Fill 'em. :thumbsup:

 

[Scottessey]

It's a '66. Thanks Fellas! :thumbsup:

 

[1stlegendtx]

66. OK now I need a picture of the serial numbers please. Do you have the O.E. engine?

 

[Neck]

The ones on the rear upright tubes are vents to keep hot gases produced while welding from blowing the puddle outwards when the welds are completed. Dunno what the ones are in the top frame loop are, probably something added by a previous owner.