I'm in the process of changing all of my 1960's three horsepower and four horsepower Briggs motors from points and condenser ignition to electronic ignition. All the new units arrived today and now I have a question. Protruding from the module are two smaller wires like in the picture below. I'm thinking that the one with the plain stripped end is the one for the kill switch. I'm also thinking that the one with the crimped on eyelet is a ground. Am I correct? Does this ground wire just get fitted beneath one of the bolts used to attach the module to the motor? I will certainly appreciate any help you fellows can give me. It's tough being an analog man in a digital age. Ogy