Has anyone ever done this freehand ?? I just bought an 8hp tecumseh w/3/4 shaft for one of my Super Broncs and it isn't drilled or tapped , but I need it to be. I didn't really want to take it apart or take it to the mower shop, so I was wandering if anyone knows the best way to do it. Do they...
I drilled out the main jet in my stock clone carb to .035 which is supposed to be a size 89 or 90 jet size. after I installed the jet back in the engine would not run wide open. It was running very rich puffing black smoke and running rough almost like the choke was 1/2 open. The only mods to...
Hi:
I have a new 72 tooth sprocket on order with no holes. I want it to replace an odd-ball 60 tooth that has only three bolt holes. Does anyone know the best way to assure accurate drilling out of the new bolt holes? I guess just align them using the center 1.375" holes in each and trace the...
Hello I purchased a MQ Power JF 200 clone. I had an extremely difficult time starting this engine whether cold or hot.
After reading I found that an idle jet drilled to 0.025 is the fix. Here is what I did and the engine starts very easily not and doesn't need choke or gas when warm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.