handle

so now that ive gotten a 11 hp motor for my go kart.. i wanna put my 6.5 that i was previously using.. so basically i am taking out my 5 hp tecumseh and putting a 6.5 clone in.. does it look like my bike can handle it?? it has no jack shaft just clutch to sprocket

I'm looking for the metal cover that goes over the two control levers on a toro power handle.I am also interested in finding complete machines or parts.If you run across anything while looking for mini bike parts,let me know.

I have an older lil indian I beleive from the photos is a sabre.The handlebars have a large plastic nut that you can unscrew .This will allow the handlebar to swing down ,probobly for transport. I need the right hand bar.Its been broken and rewelded ,but poorly done.Will buy the pair if nessessery.

Hi Guys, Here is a snap-shot of our Mini that we have had for more years than I can remember. Today my youngest son, now 22 and I decided to try and identify it. So I'm turning to your expertise for help. If you need more information, let me know and I'll do what I can. Thank You...

need one for my restoration thanks...bob

I have several bikes that could use new bars.Does any one know of any one that makes them I would like them to be chrome. Thanks

Any body have a complete Cat front fork handle bar assembly they want to sell? I have an unknown front end that was on the Cat frame to trade if interested. Thanks. Jeff

I am in need of some Scat Cat handle bars. These are the individually mounted type like seen on the "minidoodle minibike" page below. They are the ones on the red AYT 660 at the bottom of the page. SCAT CAT Thanks for any help tracking these down. Jimbo

can the HS35 handle a carb upgrade? I have a Dell from a black widow. are the port/mount holes close enough that I could modify the HS40 intake to fit the other side. Also can the HS40 flywheel and lighting coil be swapped onto the HS35? I'm thinking ahead, I have not picked up the bike...

i'm trying to order a throttle grip set, and most of the sets i see are for a 7/8" bar. when i measure the bar on my bike, it is 7/8" from the inside to the inside of the pipe. if i measure the outside to the outside, its 1". what size throttle grip do i buy?