handle

Handle Bar Risers / Clamps

Handle Bar Risers / Clamps

I do have the front fork plate (not pictured) some idiot shaved down the throttle side of the handle bars instead of getting the correct setup :doah: Other than that pretty good $35 + ship

I'm looking for a set of handle bars for my ruttman spyder project... no bends no pits don't mind if they need to be re chromed. also looking for a ruttman folding peg frame long or short please let me know joe

NEEDED Bonanza Handle bar clamps, let me know what you have. A pair would be nice or a single would be ok too.

Im lookin for some handle bar clamps for a bonanza Mx. They are the same as the one used on the bc series too.

looking for bonanza MX HANDLE BARS and gas tank ... PM ME THANKS MIKE

I am looking to buy a used MB165 with broken handle bar bracket, so that part needs to be replaced. I noticed the newer bikes have a one piece plate that is the top of the handle bar bracket. Is the spacing the same for the new top plate handle bar bracket, will it fit the older MB165 that...

Is the mounting hole pattern (size) the same on a 1970 roadster and 1969 roadster? I have a chance to get a 70 bars but want to put it on a 69. Are they interchangeable. Thanks.

hi i am looking for a set of handle bars for my mine bike project. i am looking for the ones that do not have the clamps welded on. these do not have to be clean and rust free. just pretty straight. i also need the bar clamps. let me know if you have anything. thanks. gary

I am looking for a set of bc 1400/1500 handle bars. I can get dimensions if needed but i will post a picture. Let me know what you may have and it is just fine if the chrome isnt nice.

I need a roper grab handle for this bike no rusty stuff please Thanks!!

Can someone sell me a Brake handle please for my mini Baja

Does anyone know how much it costs to re-chrome a set of handle bars and an exhaust pipe (skat kitty)? I've got a paint guy and a zinc guy. Anyone know of a chrome guy around Ann Arbor or Detroit?

hi i am in need of handle bars for a rupp roadster. they do not have to be perfact. this is not a show bike. its going to be a rider. let me know if you have somthing. thanks.

Was going to use some bicycle handle bars for a header on factory 2.8 engine. I can find different diameters of bars. Should I go close to the diameter of the exhaust port or bigger? Crome or paintable on a red bike?

bars are in perfect condition, for re-chroming or paint. asking $40 shipped located in so cal

Need a set of bars like in pic

One of the bearings on the shaft on my doodle bug forks are shot. Two questions anyone know what size these bearings are and where can I find replacement? A local source would be nice. Does home depot or lowes carry bearings like this?

One set of NOS 7/8" Blue Metalflake Handle Grips. Made by Superior, marked "Bolton Handle Grip". One grip is 7/8", one is 1". Waffle style. Works on twist throttle setup. 5" long. Got a blue paint scheme on your minibike ? $25.00 delivered: .