pipe

Looking for Tall Underseat Mini Bike Pipe w/ Muffler - 11" Clearance if anyone has one they are not using i would like to buy it from you. this one here Tall Narrow Frame Pipe w/ Screw on Muffler Honda Clone seems like OldMiniBikes no longer in stock, they have been out of stock for a while. let...

Need the entire exhaust pipe with nut and a front fender bracket. OldMiniBikes Whse had the brackets but I was told by the girl that works there, not Viki, that they have none and won't (boo hoo).

I just installed a 10" straight pipe on my HM80, how should I adjust the carb to get the most out of the engine now? The carb is at factory settings. Should I richen it up? How should I do this properly? I do not want to melt anything down by running too lean. Please help! Check out my photos.

I have a NOS chrome header pipe for the Speedway Widow Maker. 35.00 plus shipping. NOS Air cleaner for same bike 15.00 plus shipping

So I finished by DB30 with 6.5hp power fist motor (honda clone), TAV2, Uni filter, straight pipe, and a jet kit from hot rod mini bikes (whatever one they offer). So it is all installed and running but after taking it for a rip i came back, took it in the garage and did a 1 minute break stand...

Looking at getting a pipe for my Predator but I don't quite understand how these are measured. Tall Narrow Frame Pipe for Clamp On Muffler Honda Clone Narrow Frame Pipe for Clamp On Muffler Honda Clone I want the exhaust pipe to be directly under the seat but I am limited with how high...

I am running a stock Pred on my Ruttman and very happy with it. I have been looking at tuned pipes and wonder if I just change the stock exhaust out for a pipe will I encounter any problems. Not sure if I want to do the air filter and carb jet thing unless it is necessary. With just a pipe will...

Ran this summer will be sanded and painted high temp black before shipped. It's 12 inches long 15 shipped

I put on a new seat for the Sprite-more like the original. I also installed an OMBW "Weiner Pipe" on the 5.5 Carroll Stream. In case anyone was wondering,the pipe bolted right on with no grinding or machining whatsoever-and it was a tight fit. I still haven't got to ride this one yet. Damn...

I thinking about buying this exhaust pipe off of OldMiniBikes but I was wondering if anyone else has one and how good are they? Do they even fit on the Baja Heat style bikes? Also can I just use the pipe and not the screw on muffler or will this mess up the engine valves and other problems like having to...

this seems like a silly question but here it goes... This summer I made a header for my 5hp briggs out of a flange i made, a coupler and a 12 inch length of water pipe. My question is do i need tyo run a muffler on the end of this pipe, or will i run the risk of sucking cold ari through...

Pulled this off a Bonanza BC 1100 with a Tecumseh side pooper engine. It will work on rear exit Tecumseh's by turning the fitting. No heat shield was with it or back mounting bracket. Needs to be rechromed and has pits. This pipe is pretty rare and could be used on other bikes with a small 3 1/2...

I have a stock gx160 on my MB165 mini bike currently. I've been looking around for a straight pipe or just a new exhaust but it seems alot of them require a new air filter and then that leads to a re-jet. My Hondas stock exhaust barely fit without hiting the frame bar (I guess the gx160s exhaust...