torq

does OldMiniBikes have a sprocket for murray track 2 need like 66t #35 for a bike i got, friend bangged his rear end up good from torq wheelie :laugh: thats all for now thanks

I'm new to mini bikes and am unsure on what torq converter will fit a predator 212 and Azusa sprocket. I was looking into the Comet TAV.

Does any one have the Factory Torq Specs for the Predator 212?

Can somebody give me the distance between the driven and driver (on centers) for this torque converter? Also, Is the driven mounted on a 5/8 shaft? I'm trying to set up a system on a custom build but not use the backing/mounting plate. My jackshaft and engine will remain stationary...

Hi, I'm a newbee on this site and have a question about which Comet torq a verter will work on my Baha Warrior and or my Hawg Ty a varient of the Baha somewhat. The Baha has the Honda 5.5 clone and the Hawg has the real 5hp Honda. Thanks.

it's used but is in good shape no rust... might need to replace a bushing inside the driver but will work as is. comes with driver... driven and belt. only take paypals..65 shipped. the driver fits on a 3/4 crankshaft ..the driven fits on a 5/8 shaft.

Can anyone assist with how the max torque clutch should be installed on a honda clone? There is a slot at the end of the shaft that had a metel bar in it that I romeved, and if I place one of the grub screws in one of the two holes in the clutch it can go down into the slot on the shaft. But...

Are there any respectable competitors which work almost as well, but for significantly less money?

So I'm nstalling my max torq on my new hf 6.5 right now. And the key seems too big to slide the clutch on? Has anyone else had this problem? Or am I being retarded?

So I went down to CPC to get some parts yesterday and while I was there the nice lady took a group of us upstairs to look around, and there in the isle in front of me was 2 (or 3-I don't remember now because I was so excited) pallets full of BRAND NEW made in the USA Comet TAV-2s. :clap::clap...

We finally got around to modding my Doodlebug. For the engine I went with the Harbor Freight 6.5hp unit and a NOS Comet TAV30 Torq Converter for the "transmission". I originally purchased a Comet TAV2 unit with the aluminum backing plate, I fit it up and realized that the bracing cast into...

does any one no where i could get a torq converter